How to Insulate a Dog House

Wintertime can be very uncomfortable for both humans and dogs. Snow, ice and wind can make winter more difficult for your dog if it lives outside of any part of the day. Insulation of life of their neighborhoods, however, can make the difference in weather conditions and will allow him to life much more comfortable in adverse weather conditions.

Things You’ll Need:
Roulette
The hammer
Nails
Plywood sheets
Saw
Insulation
Caulk
Sandpaper

Show More Instructions

Start with the house dog that is big enough to add to. If you have an unfinished house dog, his addition and isolation will be much easier, but you can isolate just about any kind of dog house.

Choose insulation that is easy to operate and simple to install. Rolled insulation is the easiest to cut and install, but the type you choose is up to you. Be sure you choose depending on weather conditions in your area to ensure generic lipitor availability that the insulation is effective.

Measure the floor of the dog house. Insulation in the winter is especially important to the floor area, which is where most of the heat of your dog’s body will be lost. If the floor of your dog house is removable, then move it side to put insulation.

Note the floor measurements section from plywood if your dog house floor not moving. Trim section of plywood under the brand so that it will fit over the existing floor dog after insulation is established.

Trim your insulation to fit the floor of the dog house. Be sure that the section is large enough to fit over any area of your floor and provide insulation with three or four nails to hold it until you install the top covering.

Install a section of plywood over the top of the insulation, making sure that the insulation fits nicely between two floors apart. Press it firmly and nail to secure the two sections together.

Continue insulation installation by lifting each wall of your dog house and installing insulation between the sections of the wall. If your dog house does not have movable walls, measure and cut pieces of plywood to fit the walls and installing sections of insulation and wall sections as you did to the floor.

silicone on the edges of your walls and flooring sections. A sufficient amount of silicone will keep drafts and moisture from the dog house and will ensure that your insulation remains dry and in working condition. Allow the caulk to dry completely before you put your dog back in the dog house.

Sand down any rough edges of the wood and make sure that they are smooth and free of harmful purposes. Check for loose or protruding nails to avoid injury to your dog. Replace your bedding and any other accessories that had to be removed from the dog house so your dog can enjoy the most warmth and comfort in their newly insulated dog house.